Analysis of the physical and mechanical characteristics of the roadbed soils in the areas of reinforced concrete culverts
https://doi.org/10.52170/1815-9265_2024_72_97
Abstract
The article provides the analysis of the physical and mechanical characteristics of the roadbed soils in the areas of reinforced concrete culverts based on surveys conducted on one of the most important highways for the Siberian region. The physical and mechanical characteristics of the roadbed soils in the areas of reinforced concrete culverts are determined and combined into engineering and geological elements, graphs of the dependence of the soil compaction coefficient on the depth of the pit and the dynamic resistance of the soils are given, the values of the physical and mechanical characteristics of soils and the condition of the pavement in the areas of reinforced concrete culverts are compared.
It was found that in the areas of reinforced concrete culverts, when approaching the pipe, the number of defects and deformations of the pavement increases. The physical and mechanical characteristics of the roadbed soils located near the reinforced concrete culvert and at a distance of 30 m from the pipe axis differ. When moving away from the axis of the reinforced concrete culvert, the physical and mechanical characteristics of the soils improve. The conducted visual, field, laboratory studies and dynamic sensing confirm this conclusion. So, in the sinuses of culverts, the dynamic resistance of the roadbed soil is set at 3 MPa, and at a distance of 30 m from the axis of the reinforced concrete culvert 4 MPa.
The research area under consideration is relevant, since timely, accurate and rapid assessment of the physical and mechanical characteristics of the roadbed soils is necessary to reduce road accidents and rational maintenance and repair.
About the Author
E. L. Karelina
Siberian Transport University
Russian Federation
Russian Federation
Elena L. Karelina – Associate Professor of the Surveying, Design, Construction of Railways and Highways Department, Candidate of Engineering
Novosibirsk
References
1. Semenova T. V., Kuzin N. V. The influence of humidity and the compaction degree of the roadbed soils on the strength and deformability parameters. Scientific Almanac. 2016;7-1(21):451–453. (In Russ.).
2. Nikolenko D. A., Kmeta A. G. Forecasting deformations and failures of road structures of highways. Construction. 2014. P. 35–36. (In Russ.).
3. Vorobyev V. S., Karelina E. L., Repina I. B. Monitoring the bearing capacity of the main site of the roadbed in the area of culverts. The Siberian Transport University Bulletin. 2022;(63):106–113. (In Russ.).
4. Razuvaev D. A. Determination of deformation parameters of the upper part of the working layer of the roadbed. Bulletin of the Siberian State Automobile and Road Academy. 2013;(32):71–75. (In Russ.).
5. Schanz T. Experimental Unsaturated Soil Mechanics: book. Berlin: Springer Proceedings in Physics; 2007. 494 p.
6. Sed H. B., Mitchell J. K., Chan C. K. The strength of Compacted Cohesive Soils. Research conference on Shear strength of cohesive slims. ESSE Conference Proceedings. University of Colorado. 1960. P. 877–964.
7. GOST 5180–2015. Soils. Methods for laboratory determination of physical characteristics. Replacing GOST 5180-84. Introduced on the 01.04.2016. Moscow: Standartinform; 2016. 21 p. (In Russ.).
8. GOST 12248.1–2020. Soils. Determination of strength characteristics by the single-plane shear method. Approved by the Order of the Federal Agency for Technical Regulation and Metrology from 14.10.2020 № 821-st and effective from 01.06.2020. Moscow: Standartinform; 2020. 14 p. (In Russ.).
9. GOST 22733–2016. Soils. The method of laboratory determination of the maximum density. Approved by Order of the Federal Agency for Technical Regulation and Metrology of 28.07.2016 No. 891-st: and effective from 01.01.2017. Moscow: Federal Agency for Technical Regulation and Metrology; 2016. 15 p. (In Russ.).
10. Karelina E. L. Monitoring and forecasting of physical and mechanical characteristics of soils in the area of the location of culverts of highways. Specialty 2.1.8 Design and construction of roads, subways, airfields, bridges and transport tunnels. Abstract of Thesis for the Degree of Candidate of Engineering. Karelina Elena Leonidovna; The Siberian State Automobile and Highway University. Omsk; 2023. 24 p. (In Russ.).
11. Vorobyev V. S., Karelina E. L., Bender O. A., Katalymova K. V. Statistical models of physical and mechanical characteristics of highway soils in the area of culverts. Bulletin of the Siberian State Automobile and Road University. 2018;15(62):560–573. (In Russ.).
Review
For citations:
Karelina E.L. Analysis of the physical and mechanical characteristics of the roadbed soils in the areas of reinforced concrete culverts. Bulletin of Siberian State University of Transport. 2024;(5):97-105. (In Russ.) https://doi.org/10.52170/1815-9265_2024_72_97
Views:
5
Email this article 